Testimonials

"Mark at Clear Bumper actually put the concept I thought of into reality. Kudos to him. This is the best solution to those of us living in the city and were tired of looking at our scarred bumper. THIS PRODUCT Is awesome and Mark is a super nice person to deal with.I just had the bumper done and I am going back for the door treatment. He is located at Botta Auto Body on Sacramento St."

By Alan C. San Francisco, CA

Door Edge Protection

Save your doors from chips and other parking lot mishaps with ClearBumper transparent door edge strips. Our strips are clear polyurethane protective film that is 8 mil thick. We do have 14 mil upon request. The film is also puncture resistant and will not yellow. All that needs to be done is to wipe the edge clear of wax. Then follow instructions and in a few minutes your doors are protected.

Our strips are 3/4 inch wide and 2 1/2 feet long. Each package comes with 5 door edge strips (4 for each door and one extra just in case). If you want to custom fit, please use a pair of scissors to cut strips.

Check out prices and quality. NOBODY COMES CLOSE!!!

Installation Tips:

Fingerprints, skin oils, dust, or dirt in the adhesive will show up easily through the clear film and are very difficult to remove. Hands must therefore be very clean during the entire door edge guard film application process. Do not try to install in windy conditions. For best results surface tempetures should be between 55° F - 85° F.

Door Edge Protection Step 1 1. Clean the door edge on both interior and exterior surfaces using the alcohol/water solution and a clean lint-free cloth.

 

Door Edge Protection Step 1 2. With the film liner still in place on the door edge guard film, hold it to the door edge and check for fit. Trim to the desired length.

 

Door Edge Protection Step 1 3. Spray hands with the alcohol/water solution. It is not necessary to wet the film or the vehicle with solution due to the narrow width of the film. Fingers wet with the solution will not leave fingerprints in the adhesive.

 

Door Edge Protection Step 1 4. Remove the liner, being careful not to touch or contaminate the adhesive.

 

5. Beginning at the top, press the film onto the door surface with about half of the width on the door edge, and half extending beyond the door edge. Continue down to the bottom of the film.

6. Carefully fold the film around the door edge, beginning at the top and moving down.

7. Check for air bubbles and ensure that all surfaces are well secured with finger pressure.

8. Allow the adhesive to set up and dry for at least 24 hours before washing your vehicle.

Buy Now
Free shipping on purchases of over $100 Buy Clearbumper Kits for 149.00 Before & After

Damaged Bumper - Before Bumper - Before

Damaged Bumper - After Bumper - After

Our customer reviews at Yelp

Press Releases


San Francisco - Newspaper Clipping

Featured in San Francisco Daily's newspaper.

Winner of SFGate's BayList Best

Winner of SFGate's BayList Best.