Installation Guides
You don't have to be a mechanic to install our product. Just make sure that the bumpers are clean. Then using a simple water solution applied to both the ClearBumper strip and the vehicle, place the strip on the vehicle and move into position. Remember to keep material, vehicle, and fingers wet to avoid premature adhesion. Then simply squeegee the excess air and water from between kit piece and vehicle. That's it!
What You need for Bumber Strip Installation
Tools
The recommended tools for installation are included in your ClearBumper kit.
(2) Two Squeegees
(3) Three lint free towels
(1) One Box Cutter
(1) One Spray bottle
Soap Solution
In the bottle provided fill 3/4 with water. Add 3 to 4 drops of any liquid hand soap. We recommend using No More Tears. The solution should feel slippery, not slimy. If the solution is not slippery enough add a little more soap. If it is to slimy pour out some of the solution and add more water.
In second bottle fill with Isopropyl Alcohol. Most pharmacies and some groceries carry it.
After you have completely installed the ClearBumper strip you can spray a Isopropyl Alcohol mist over entire strip and wipe clean. The alcohol will pull the moisture from the edges.
Step by Step instructions of Bumper installation »
ClearBumper Customer Care Sheet
